Forum Replies Created

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • July 14, 2010 at 2:20 pm in reply to: Memory Toy Volume Boost Problem #110199
    ynot
    Member
    Quote:
    Thanks for the information. Did you get a replacement that did work?

    Yeah…but it wasn’t a EHX pedal.

    July 14, 2010 at 1:49 am in reply to: Memory Toy Volume Boost Problem #110192
    ynot
    Member
    Quote:
    Hi,

    I also suffer from the volume boost that is there no matter what I set the blend to.

    I see there are 3 trimpots inside the Memory Toy. One is for the Modulation Depth. Could one of those others be for gain?

    If not, can i return the unit and get a replacement hoping that one won’t have the boost?

    Thanks,

    Ronald

    This is the reply i got from EHX when I asked about the volume issue.I ended up returning mine:

    “Hello. Unfortunately that is normal for this unit and there is no trim pot adjustment to lower the gain.
    Regards,”

    April 24, 2010 at 5:12 am in reply to: Memory Toy Volume Boost Problem #108871
    ynot
    Member

    Thanx but I’ll probably just return it & get something else.If the pedal is incapable of unity gain & don’t have an adjustment then I’d rather just not use it.Last thing I need is an extra pedal in my chain for each pedal I have to compensate for.

    April 24, 2010 at 1:33 am in reply to: Memory Toy Volume Boost Problem #109362
    ynot
    Member

    I’m also hoping for an answer to this,soon too or mine is going back.I just got it today & noticed a big volume boost.This screws with my whole setup because my main amp has no FX loop & since it also has no master volume everything is based around gain staging in my chain (cln/dist etc..).Any info on this would be greatly appreciated.

    March 15, 2010 at 12:30 am in reply to: Expression Pedal #108525
    ynot
    Member

    Does anyone know the proper way to split/combine the signal (to one amp),maybe I’ll go that route since I have a volume pedal anyway? The splitting part doesn’t worry as me much,I suppose a simple Y-cable would suffice so long as it’s after a buffered pedal but what about combining the two? Should there be a resistor or something in line to keep the two signals from stepping on each other? I’m not adverse to making it myself if I have to.

    March 12, 2010 at 11:09 pm in reply to: Expression Pedal #108431
    ynot
    Member

    How are you splitting/combining the signal,Y-cables? If so whats that doing to the tone & impedance?

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)