Forum Replies Created
-
AuthorPosts
-
January 15, 2021 at 4:40 pm in reply to: Vintage EHX Clone Theory Chor/Vib knob does not do anything #126738The EH ManModerator
If you’re getting some modulation I’d say the MN3007 is OK.
January 15, 2021 at 4:34 pm in reply to: Vintage EHX Clone Theory Chor/Vib knob does not do anything #126736The EH ManModeratorYeah, I wouldn’t worry too much about that.
January 15, 2021 at 4:30 pm in reply to: Vintage EHX Clone Theory Chor/Vib knob does not do anything #126734The EH ManModeratorI would suspect a broken trace going to the pads the pot is soldered to. Barring that, there may be an issue with the flange switch.
The EH ManModeratorI’m assumning the pcb is made and populated in China but is assembled into the chassis in NYC.
November 21, 2020 at 12:01 am in reply to: A stupid question I’m sure about the Big Muff Pi Bass Pedal #126627The EH ManModeratorIf it has a battery in it, usually the led will only light up if something is plugged in to the input jack.
The EH ManModeratorWouldn’t hurt to check with EHX. They may fix it for you.
The EH ManModeratorWhat’s the circuit board look like? Is there a model number on the board?
The EH ManModeratorIt’s a 3 pole, 2 position rotary switch.
The EH ManModeratorThe vintage Bad Stone used 2 batteries for +/- 9vdc, not 18v.
The EH ManModeratorBad Stone.
August 7, 2020 at 10:20 pm in reply to: Vintage Deluxe Electric Mistress – No Sound When Footswitch is Pressed #126343The EH ManModeratorIf you have no idea about electronics you’d be better off sending it to someone who does.
August 7, 2020 at 9:25 am in reply to: Vintage Deluxe Electric Mistress – No Sound When Footswitch is Pressed #126341The EH ManModeratorYou should probably send it to a tech. Sounds like it could be a power supply issue or a bad component.
The EH ManModeratorIt might be something as simple as a bad solder joint on the pot, but it might be something more complicated. Best to get it to a tech.
The EH ManModeratorQuote:Also I dont know if this matters or not but when not having any power source in it the clean signal still passes through until i step on the switch then it cuts the signalThat’s normal. You might contact EHX customer service in my link and see about sending it in for repair.
The EH ManModeratorDid you try it with a battery again? Also, open it up and see if there are any loose wires or something smells burned.
-
AuthorPosts