Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • July 27, 2016 at 8:00 am in reply to: Stereo Memory Man with Hazarai – signal level and modulation query #121767
    russ5254
    Member

    check out theodor’s comments below. i really think he got it.
    My SMMH is in a parallel loop using Boss LS-2 and i hav to use Rin and Lout when connected in parallel with a Line6 Echo Park so that i don’t have the out of phase dry signal sound when both pedals are off.

    Quote:
    I’m sure it would compete with the strymons and eventides if there were just minor changes actually…forget adding tons of modes- essentially its great but a few more improvements on how it does things would be great.

    Volume drop is due to the phasing of the ouputs i’m pretty sure. There are certain configurations of how you plug in outputs that work(but mean the effect is unusable/lost functions)…or actually hooking up to stereo of course….its just how the two ‘phased’ outputs are summed into mono they cancel on both dry and effect-at about 45 degrees each or something because phase switching doesn’t help much. Stereo is fine, one channel only is fine, running through both channels in series is fine with suitable changes like buffers or preamps inbetween.

    I think there are multiple modes so there are presets, the only reason for adding modes is say if they give 3 presets for each mode, then not need 1 sec, 3 sec versions so include somethng else maybe just slightly different like rate knob, oscillation whatever…

    January 10, 2014 at 4:50 am in reply to: Stereo Memory Man with Hazarai tips, tricks, and clips #119610
    russ5254
    Member

    ok, i’ve managed to find the way to connect the Hazarai properly in a parallel loop without encountering the out-of-phase problem.

    I have to use Input/R and Mono/L out jacks.
    When Haz is engaged, the “dry” signal actually goes out-of phase.
    So blend must be set to 100% wet. Anything less and the phase mismatch starts to happen.
    So i guess that’s what was meant by “Dual 90 out of phase outputs”…..

    So my routing for Hazarai in parallel with Line6 Echo Park using Boss LS-2 is as follows:

    LS-2 input = guitar+pre Echo Park effects (dirt/fuzz/wah..etc)
    LS-2 A send -> [strong]Haz Input/R -> Haz Mono/L out[/strong] -> LS-2 A return
    LS-2 B send -> Echo Park Mono in -> Echo Park -> Mono out – LS-2 B return
    LS-2 output = to Amp

    Guess I will not be able to fully enjoy the “lush chorus, dense reverb and extra effects!”:-P

    January 7, 2014 at 4:14 am in reply to: Stereo Memory Man with Hazarai tips, tricks, and clips #119608
    russ5254
    Member

    hi guys,
    Hope someone can help me out a bit here.

    i am trying to setup my line6 echo park and the Hazarai using the Boss LS-2 (always on in A+B mix mode) such that the delays are running in parallel whenever i turn them on.
    both units’ levels are balanced properly so that there are no volume jumps/drops when both or either one is turned on.

    unfortunately the Hazarai is not doing too well in this parallel loop situation.
    i’m always getting an out of phase sound from it whenever it is turned on.
    the thing about the LS-2 is that it has no direct dry signal through so my dry signal has to come from either one of the delay units.

    i have tried the following:
    1. blend at 100% wet on hazarai and use echo park to provide the dry sound (mix knob at 50-60% to make the repeats a little more audible)
    2. blend at 50-60% on hazarai to provide the dry+delay/reverb and echo park at 100% wet
    3. use only the mono in/out for send/return
    4. use only the stereo in/out for send/return (i tried this after reading from jvm forum that it worked in a parallel loop but in that situation it was in series with a vox time machine)

    i read in andertons.co.uk website that the unit has a “dual 90 out of phase output”..
    is this true and is it possibly be causing my phase issues?
    do i need to have both outputs going into the loop in order to use it as a parallel effect to mix with a dry signal??

    sorry for the long post & thanks in advance for any replies!

    December 19, 2013 at 5:57 am in reply to: Stereo Memory Man with Hazarai tips, tricks, and clips #119575
    russ5254
    Member
    Quote:
    hi, could you please let me know how to set a dotted 8 delay with memory man with hazarai and how to set it in different tempos?

    thank you

    see pg 14 of Boss DD7 manual on how to tap dotted eighths..
    http://media.rolandus.com/manuals/DD-7_OM.pdf

    or this……

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)