Forum Replies Created

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • November 6, 2013 at 5:37 am in reply to: Vintage box style screws #119477
    rickamortis45
    Member

    For some reason, I cannot find these screws at any hardware or specialty fastener store where I live. I don’t understand why they would be uncommon, but no one around here seems to have them? I need some and don’t know where to get just a few. Any suggestions appreciated. Screws were the last thing I thought I’d be looking for after fixing the other stuff. It’s always the little things I guess? Just wanting to seal them back up now that they work right again. My next quest is reviving the mysteriously dead vintage Micro-Synth. One day, it will buzz and sweep again.

    October 15, 2013 at 2:23 am in reply to: Dead Small Clone #119406
    rickamortis45
    Member

    Hey, thanks again. I haven’t went back into the Micro Synth yet. I have to free up my ‘bench’ aka kitchen table. Do you know where to get case screws for old E-H effects like the Small Clone? I couldn’t find any at the hardware store or the specialty fastener store. I figured they would be common, but I had no luck when I tried to find some.

    October 12, 2013 at 12:49 am in reply to: Dead Small Clone #119402
    rickamortis45
    Member

    Hey, thanks again. I’m not sure what the setting of the trim pot does? I know I’ve moved mine. As far as the Micro Synth, it was stored cleanly, it just went dead. Power light is on. It’s an old one. It was suggested some time ago by the E-H Man to check the voltage around the 2N6111 in the power supply. I have a schematic, but haven’t looked inside in a while. I got intimidated when I saw how it was put together.

    October 11, 2013 at 4:36 am in reply to: Dead Small Clone #119400
    rickamortis45
    Member

    Guess what? I’m swirling again! I had mistakenly replaced the 4558 with the LM 358. When I realized my mistake, I replaced the 358 and bingo! I was given this broken pedal in the early 90’s when I was a tech fixing Hammonds, Leslies etc. Thank you for your help. My next EHX pedal project is my old Micro Synth that somehow died while in storage.

    October 9, 2013 at 11:06 pm in reply to: Dead Small Clone #119392
    rickamortis45
    Member

    Hi, thanks for the reply. At this point, I’ve replaced the 4047, the LM358 and the MN3007 with no success. I don’t have a schematic and have run out of ideas. Any help would be appreciated.

    April 21, 2009 at 11:07 pm in reply to: Vintage microsynth #95922
    rickamortis45
    Member

    Thank’s for the reply! My scheme show’s a 2N6110. Would the power light still be on?

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)