Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • November 15, 2014 at 2:42 pm in reply to: Memory Man problem #120401
    NuckChorris
    Member
    Quote:
    Okay, can you follow a schematic?

    EHXDMM-Factory.jpg

    Build your self the audio probe from this page http://www.diystompboxes.com/wiki/index.php?title=Debugging

    Check you have signal at the left side of the .1 cap coming from the input, then check pin 1 of IC1A and the outside lugs of the blend pot to start with.

    Does the direct output work? It might be the foot switch, you can use a multimeter to test it for continuity.

    Thanks. I’ll get a meter and check this. It may be the footswitch. The direct out doesn’t work either. The light goes off and on with the footswitch but I’ll check it with a meter as well

    November 15, 2014 at 1:30 am in reply to: Memory Man problem #120399
    NuckChorris
    Member
    Quote:
    Have you checked all the wires are properly connected inside? Otherwise a schematic and a multimeter will be required.

    Yeah I don’t see any cold solder joints or anything like that

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)