Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • September 11, 2013 at 6:49 pm in reply to: 8 step program questions #119351
    markxus25
    Member

    Thanks for getting back to me, that explains a lot! I went back and plugged the unit into the VCO 2 CV In, instead of the CV In for both VCO’s, and was able to get some good repetitive loop effects thru the VCO 2, while playing the keyboard thru the VCO1.

    The rep at E-H was nice enough to answer my email the same day, unfortunately he indicated the unit is defective due to the problems I had with the Mode switch. After re-booting a few times, including a factory re-set, I did get it to work properly for a bit, but don’t know if it will freeze up on my again. So back to the retailer it goes…

    Thanks, Mark

    September 10, 2013 at 4:27 pm in reply to: 8 step program questions #119349
    markxus25
    Member

    Can anyone help me with my 8 Step. First, the Mode knob turns on all three mode LED’s, which then all start flashing, as I am trying to follow directions “press mode knob until (mode LED you want to change) comes on.” Is it just…defective? I can’t get it to cycle thru the three modes, that is one mode LED at a time.

    Also I plugged it into my Korg MS20, into the “CV In” socket. This seems to disable the keyboard, I get only one note whichever key I press on keyboard. I do get it to play an arpeggio, but only for that one note. I can repeat the arpeggio, and change tempo, but it only plays…one arpeggio. Is this all it does???

    Thanks, Mark

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)