Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • January 1, 2019 at 7:15 pm in reply to: Electro Harmonix MIG 50 voltage on plate? #124674
    mahdi
    Member
    Quote:
    Please write the techs at
    info@ehx.com

    i did write them , but didn’t get any respond from them , thats why i’m asking here

    December 30, 2018 at 4:53 pm in reply to: Can OD pedals handle less than 9v? #124670
    mahdi
    Member
    Quote:
    Good evening, I hope the holidays find you well.

    I was wondering if OD pedals can handle lower than 9v.

    I have an mxr isocomp that let’s me dial down the voltage. I’ve played with the DOD gunslinger and it can handle anything at or under 18v. Dialing down the voltage is found on the Germanium OD and that’s a neat effect.

    If it isn’t recommended That’s fine. I have a small collection of EHX OD and thought this might be another avenue I could experiment with.

    Thanks

    if a fuzz do then an od does too , and the best example would be the : Maestro FZ-1 , it was run on two batteries of 1.5v

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)