Forum Replies Created

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • in reply to: Sovtek Amps Anyone? #117579
    JimmyZ
    Member

    I prefer the RP Valve models mostly.The newer non-valve units are absolutely terrible in my opinion.
    Some say since I use tube amps that the valve is not needed…I strongly disagree 100%.
    If I had the $$$…there would be an Eventide 3000 sitting here :)
    JimmyZ

    in reply to: Bad Stone wiring help? #117570
    JimmyZ
    Member

    Disregard my question…finally after hours of looking online,found one photo locating wire location.
    http://www.pedalarea.com/images/EH_bad_stone_03.jpg

    in reply to: Bad Stone wiring help? #117566
    JimmyZ
    Member

    Wow.just noticed this thread is 2 years old !!!

    in reply to: Sovtek Amps Anyone? #117565
    JimmyZ
    Member

    Never mind…found the answer and now understand what you asked.
    http://ericsgearpage.blogspot.com/2011/04/digitech-xp-300-space-station.html
    No…do not have the presets and just learned the XP300 existed.
    Sounds like that model has a bible sized manual :(

    in reply to: Sovtek Amps Anyone? #117564
    JimmyZ
    Member

    Can you be more specific on the presets?
    Honestly…not quite sure what you mean.
    Both RP7 and RP20 have the factory presets.
    I have yet to interface the RP20 to a PC.

    in reply to: Bad Stone wiring help? #117555
    JimmyZ
    Member

    Great forum first off !
    I had been searching the internet for wiring a Bad Stone phase shifter that was given to me.
    Noticed first off the positive wire was disconnected…easy to figure out.
    Still not working,so decided to take it apart and do a thorough check.
    Found another blue wire disconnected that goes to the foot switch which has 3 wires total.
    Have no clue where it goes and looking at various schematics,none seem to be this particular
    model.This also has only one 9v battery holder.
    Hope these photos are good enough for someone to help me out.They were taken on the fly.
    Is there a specific schematic available for this model?
    Looking forward to hearing this again after many years.
    JimmyZ

    [img][/img]123.jpg
    http://i430.photobucket.com/albums/qq22/N2NXZ/DSCF0014-4.jpg
    http://i430.photobucket.com/albums/qq22/N2NXZ/new-1.jpg
    Above shows top red line pointing to blue wire (disconnected) and bottom shows connection to Foot switch (3 wire).Where does it go?
    [img][/img]DSCF0025-1.jpg
    http://i430.photobucket.com/albums/qq22/N2NXZ/DSCF0018-6.jpg

    in reply to: Sovtek Amps Anyone? #117554
    JimmyZ
    Member

    Not sure if I had posted on this amp,but I found a Sovtek MIG100 on a curb…sounds great on 2-4/12 Marshall JCM800 Cabs after sent to John Nau for repairs.He also overhauled my (original)Marshall Super lead 100 1959 head.
    Took many years to obtain my gear.But was very lucky as the Marshall head was purchased used for about 50$ 32 yrs ago.The amp without the cabinet on top of the Sovtek is a Marshall MG100 HDFX 100 W bought for $5.00 at an auction ! My mom actually remembered me saying Marshall my whole life and bought it…mom rulz.
    One last comment…the guitar in the center has a white pickup.It is from a guitar Paul Stanley smashed on stage.Believe it or not…it sounds fantastic.
    [img][/img]new3.jpg

Viewing 7 posts - 1 through 7 (of 7 total)