Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • August 17, 2018 at 10:53 pm in reply to: Mel9 – suddenly, no output when engaged #124205
    jeffy
    Member
    Quote:
    I have a similar problem to that described above with the Synth 9 pedal. I works just fine in bypass mode. When I hit the footswitch, the light comes on and no synth sounds in any of the 9 channels. This happened after about a week of on and off usage. I am using the EHX supplied power chord/adapter and it is plugged directly into my wall socket. I am now a bit nervous about using this pedal on gig.

    I have tried removing all cables, switching guitars, amps etc. The problem seems to be intermittent. It happens occasionally, but not all the time.

    Any advice to help fix this issue would be appreciated as I really want to use this pedal on gigs – synth sounds are fantastic when it works!

    FYI – I also own KEY9 and B9 pedals and have had no problems with either one

    This is the same situation I have with the Mel 9. Jeff Abbey

    August 17, 2018 at 9:32 pm in reply to: Mel9 – suddenly, no output when engaged #124204
    jeffy
    Member

    I love my Mel9 – that is, when it works. About 50% of the time I want to use it – I get the clean non effected output out of that 1/4″ jack, but on the Mel9 output jack-I get nothing. No noise, no signal, nothing. I am using the proper supplied power wall wart. It’s hit or miss at gigs, which makes it very frustrating. Any thoughts? Thank you! Jeff Abbey

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)