Forum Replies Created
-
AuthorPosts
-
February 9, 2024 at 1:16 pm in reply to: Portable V256 Vocoder – Amp Speaker Advice for Pedal Output #209006insultcomicdogParticipant
Thanks for the tip about a pre-amp. I have a headphone amp kit I build a while back that I’m going to try:
https://www.worthpoint.com/worthopedia/banzai-v2-cmoy-headphone-amplifier-173543067
My main concern is blowing up the pedal, power amp or speaker because of incompatibility.
My plan is the output the pedal to headphone amp then output headphone amp to power amp (9-20V 20W TDA2030A Class AB Mono Power Audio Amplifier). I will report back with my results.
Is there a portable pre amp you would recommend to use with the power amp and speaker listed above?
February 9, 2024 at 8:54 am in reply to: Portable V256 Vocoder – Amp Speaker Advice for Pedal Output #209000insultcomicdogParticipantUpdate.
I switched my amp to this 9-20V 20W TDA2030A Class AB Mono Power Audio Amplifier.
https://a.aliexpress.com/_m0cp1BG
And the speaker is now:
Tang Band W2-800SL 2″ Aluminum/Mg Full Range Speaker Driver
I’m using a 1/4 jack shielded patch cable to connect v256 pedal output to amp with a 3.5 mm mono jack to connect to the amp.
When I tested setup (no blue smoke was released!), but the sound volume is quite low. For example if I connect an iPod to this amp and speaker I can fill the whole room with sound, but using the v256 pedal I barely can fill my desk with sound.
Is there anything else I can do to increase the volume besides getting a more powerful amp? Am I using the wrong cabling/adaptor to ouput sound to amp?
-
AuthorPosts
