Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • in reply to: Russian Big Muff Pi and Holy Grail troubles #104843
    i_amnt
    Member

    bump?

    in reply to: Russian Big Muff Pi and Holy Grail troubles #104440
    i_amnt
    Member

    just tried out the Russian Pi Big Muff again. when i first plugged in i didn’t get any sound when turned but i turned the sustain knob and a crackle came and i had signal, played on for an hour or so, then came back a few hours later and whenever it was in the loop there was a terrible hum. This brought back memories of what its problem was a year or two back, it would eat up a battery in a day or less.
    i opened it up and saw that, where the red and white wires coming from the 12volt battery attachment solder to the board, it looks pretty black and crispy.

    i did have to replace the power supply for the holy grail because the old one had broken. i just dug it out and now it wont come on at all and wont let a signal through what so ever.

    they both seem pretty doomed at this point

    in reply to: Post Your Big Muff(s) #104354
    i_amnt
    Member
    Quote:
    i wish i had a mogwai muff!

    i have a deluxe big muff pi modified so the output signals of both comp and muff circuits are higher.
    it’s way nice!!
    sorry i couldn’t get a picture of it “solo”, i didn’t post this picture to show off!!

    the_floor_by_mouldeck.jpg

    i dont mean to hate, but i am curious- what is with the masking tape on select pedals?

    in reply to: Russian Big Muff Pi and Holy Grail troubles #104329
    i_amnt
    Member
    Quote:
    Leaky capacitors allowing voltage onto the pot could cause that. Bad solder joints at the pots is also another possibility.

    okay, i think i’m going to try and resolder those joints. if that doesn’t work i guess ill try putting in new capacitors. not sure what kind i’d need exactly or how hard they could be to gt ahold of.

    thanks

Viewing 4 posts - 1 through 4 (of 4 total)