Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • February 22, 2022 at 3:37 pm in reply to: Mel 9: No sound when switched on in pedal chain #187144
    gallegosmc
    Participant

    Hello EHX (and LFinston),

    To add to LFinston’s thread where I responded my experience, when my issue came, I was using the power supply that came with the EHX Mel9. Just to add, this situation doesn’t always occur when using Mel9.

    Lastly, thank you EHX, as well, for providing the email address for EHX support…I can’t recall how i attempted contacting as it’s been some time now.

    Cheers and good luck, LFinston.

    MG

    February 21, 2022 at 12:50 pm in reply to: Mel 9: No sound when switched on in pedal chain #187136
    gallegosmc
    Participant

    Hello LFinston,

    This sounds close to my experience. I too have the Mel9, worked fine and consistent for some time, then one day a similar scenario hit where it wouldn’t kick in despite ‘lights on’…note this was the only pedal between guitar and amp. I found a few notes suggesting disconnecting the power supply connector from the pedal, re-connect and sure enough the pedal was enabled, worked fine.

    Not an ideal workaround, but when I hit this issue, these steps seem to be consistent.

    Replacing a good idea, but since there are notes out there for this issue, doesn’t guarantee it won’t happen on a replacement. I had reached out to EHX but unfortunately, no response.

    Hope this helps and good luck!

    MG

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)