The Ronsound schematic is the only one I’ve found on the web(its titled “Small Amp”) but it doesn’t seem to match the Freedom Brothers amp I have, from looking around on the net, the little bit of info I have found has 2 different PCB’s one with holes for the jacks and one without. Anyone out there with any gut pics of one of these?
Thanks
Barry
I know this is an old thread but if you are still out there Bill, I was wondering if you still have this pedal and if you can tell me the value of the green cap on the solder side of the board and where its going to? I have one of these and recently got around to trouble shooting it and found a broken lead right where that cap is below the two flying resistors. Anyways figured its worth a shot to ask. Thanks
Barry
Hey there, new to the forum, I have one of these EH-400’s(early one no delay etc.) and it works pretty well, but its calibration is all over the place, I was wondering if anyone can tell me what the three trim pots do? On the schematic I can only find 2 trim pots listed , both at 5k one for fine tuning and the other for intonation. The third trimpot mine has is 1K and it does some thing to the tuning but I can’t figure out in what order I need to calibrate this at. Any help would be amazing!!!!!!!!! Thanks Barry