Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • April 11, 2011 at 2:17 am in reply to: DMM 90’s delay knob issue #114964
    esharp
    Member

    Don’t think solder joints as that would be more all or nothing. Everything looks good. Was able to test pot without removing. Is the amount of delay a simple voltage controlled input to the MN3008s of which the pot is one side of a voltage divider is it more sophisticated than that? Guess I should try to find a schematic.

    April 10, 2011 at 10:07 pm in reply to: DMM 90’s delay knob issue #114961
    esharp
    Member

    Smooth as silk from 0-100k. Next?

    April 10, 2011 at 9:56 pm in reply to: DMM 90’s delay knob issue #114959
    esharp
    Member

    So I should be able to put a meter across it and see if that’s the case right?

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)