Forum Replies Created
-
AuthorPosts
-
Electro HarmonixKeymaster
The Hum Debugger is digital and will help with any 50/60-cycle hum being created by your power outlet. Humbuckers can still let some hum through so it could potentially help. That said, there are different kinds of noise and some that are created by other things aside from your guitar’s relationship to the power outlet. Buzz and other noise like that from a loud distortion pedal will not be taken care of by the Hum Debugger.
Electro HarmonixKeymasterHey Steve,
While you certainly can load the cab with whatever you want (it is just a box after all), please take note of the following.
•The 2×12 cab is wired in series. If you wanted use 2x 16ohm speakers, you’ll want to wire them up in parallel so you get an impedance of 8ohms. In series, impedance adds while in parallel, impedance divides. You don’t want in impedance of 32ohms.
•Using these speakers, you’ll end up with a power rating of 40-50 watts. If you are planning using this with the MIG-50, you’ll want to keep the power rating at at least 50 watts unless you plan to only run it at low volumes. If you were planning on using this with a lower wattage amp, then have at.
•If you wanted to just drop in new speakers without having to worry too much about wiring and all that, a more direct replacement would be 2x 8ohm speakers with a power rating of at least 30 watts.Hope this helps.
Electro HarmonixKeymasterPlease email our techs at info@ehx.com; they can assist you.
February 10, 2023 at 10:07 am in reply to: Tone control unresponsive unless at zero or full (10) #197870Electro HarmonixKeymasterPlease email our techs at info@ehx.com; they can assist you.
Electro HarmonixKeymasterWe hear you. Hang tight and thank you for all that you have done for these forums. Tx.
-
AuthorPosts
