Forum Replies Created
-
AuthorPosts
-
January 25, 2012 at 8:27 pm in reply to: The What Is The Current Draw For That EHX Pedal Thread #116854ech0esMember
what could be the minimum ?
January 25, 2012 at 7:08 pm in reply to: The What Is The Current Draw For That EHX Pedal Thread #116851ech0esMemberHello
I would like to know if the caliber 22 can run with less mA ?
the manual says 18VDC 1,5A
Can I use a different voltage or amperage ?
June 5, 2010 at 12:16 pm in reply to: New Devices: Germanium^4 Big Muff &, .44 Magnum, Freeze, Neo Clone, & Headphone Amp #104701ech0esMemberwe need a full stereo ’22 power amp, with dual inputs and dual outputs, and recording output with cab simulation !!!
ech0esMemberthanks !
it was just an idea…a bad idea
ech0esMemberQuote:8 – 16 Ohm OUTPUT Jack – Connect the 22 CALIBER’s OUTPUT jack directly to a speaker cabinet.WARNING: NEVER CONNECT THE OUTPUT OF THE 22 CALIBER TO THE INPUT OF ANOTHER AMPLIFIER, AN EFFECTS PEDAL, MIXER, COMPUTER, COMPUTER INTERFACE OR ANY OTHER SIMILAR DEVICE.
Yes but the pedal is just a volume pedal, so just a potentiometer, no real electronic components.
Quote:May I ask what you’re trying to do? To use two cabs I guess you’re looking for two different sounds but if they come from the same amp (the 22 cal) what’s really the difference?The goal is not to have two different sound, but two different SOURCES for one sound. To pan my sound from left to right if i place a cab at my left and one at my right.
Quote:Would you run different fx chains? Because you can’t run pedals after the 22 either. Also you should be aware that EHX no longer recommends it for 4 ohm loads.The caliber22 is not ok with 4 ohm loads ? where did you see that ?
ech0esMemberthat’s what I think, an engeneer from ehx would be useful
-
AuthorPosts