Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • January 23, 2010 at 12:14 am in reply to: Hum Debugger – broken switch #106731
    Chasm
    Participant

    I keep replying to myself…this is odd,

    Anyway – SUCCESS! I was able to figure out what switch to use, and found it on DIGIKEY, part number EG2456-ND (MADE BY E-SWITCH, P/N 200MDP1T1B1M2QEH).

    It is easier to desolder the old switch if you take it apart carefully. The toggle part can be pried off, then cut the red plastic body with a small wire cutter to reveal the leads. Then use solder-wick to remove them and clean out the pcb holes. Insert the new switch and solder it up.

    When re-installing the PCB in the box, do not leave any nuts on the switches threaded collar.

    December 25, 2009 at 5:31 pm in reply to: Hum Debugger – broken switch #105695
    Chasm
    Participant

    hmmm, I guess EH tech support doesn’t really read these. OK, my unit is broken – poor design if you ask me. using a thin handled toggle switch was a bad idea guys; a low-profile slide switch would have been much better.

    So, how do I get this fixed? I’m a degreed EE with 28yrs experience – much of it in amp design — so if you can give me a part number, I can replace the switch myself.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)