Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • February 7, 2017 at 6:27 pm in reply to: 22500 loper problem #122585
    Blueslooper
    Participant

    Hi EHX Staff.

    Thanks for the note.

    When I turn the looper on I see the -28- shown, which I guess means that the firmware is up to date.

    What I did since find out is that the looper only freezes when I select one particular bank (Nr 9 in this case).
    I ran my virus protection (Kasperski) scan on the drive which had the EHX card in it.
    This showed an “error” and advised to run the repair tool.

    The EHX manual says that there is a “Skandisk Utility” on the SD card.
    I couldn’t find one.

    I ran the repair tool in Windows 10 by right clicking on the relevant drive in Explorer (ie the EHX SD Card), selecting “tools” and running the repair tool.
    This seems to have rectified the problem with Bank 9 causing the looper to freeze…..as it now doesn’t.
    Haven’t tried it actually connected to a guitar/amp etc yet though.
    Fingers crossed !!

    January 23, 2017 at 1:57 pm in reply to: 22500 loper problem #122534
    Blueslooper
    Participant

    Hi

    I also have a problem with mine.
    Bought it very recently and have hardly used it.
    Seemed to work OK with my first try.
    Now it just seems to freeze.

    When turned on, all seems good, but as soon as you try to do something – eg select a loop bank, it just freezes. None of the buttons do anything.
    If I unplug and plug in, all seems well again until you actually try to do something, when it freezes again.

    I can’t see any help in the manual.
    Will let you know if I get to find out what’s wrong.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)