two for one:

1) green russian small stone

– this was given to me as a failed father/son repair job. instead of the on/off stomp switch they installed an internal toggle switch. most of the wires had been desoldered, so i’m at a loss for where the wires go to the color switch and to the stomp switch. if possible i’d like to install a 3pdt switch instead of the standard switch.

2) micro-synthesizer

– this had some loose wires from the in/out jacks on the circuit board and i soldered them to what looked logical to me, but if someone could tell me proper solder points then i can figure out what else is going wrong with this pedal.

Thanks!