Home › Forums › Help/Technical Questions › V256 midi CC

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • February 21, 2017 at 2:18 am #84796
    Yahrii
    Member

    Hi.

    I’m wondering if the “push” function of the “mode” knob (the act of pressing the white button) can be controlled by midi.
    Instructions give CC numbers for everything exept the mode knob.

    Also, if it’s not possible, I found another way to get the same result, which is, in my case, swiching between PC 8 and PC 17 (if I recall correctly). this swiches between “preset inst controll” and “non-preset inst controll”. Is there something like a foot controller that just swiches between these patches or that can be assigned to switch between them?

    Thanks in advance

    March 1, 2017 at 5:30 pm #122645
    Flick (EHX Staff)
    Moderator
    Quote:
    Hi.

    I’m wondering if the “push” function of the “mode” knob (the act of pressing the white button) can be controlled by midi.
    Instructions give CC numbers for everything exept the mode knob.

    Also, if it’s not possible, I found another way to get the same result, which is, in my case, swiching between PC 8 and PC 17 (if I recall correctly). this swiches between “preset inst controll” and “non-preset inst controll”. Is there something like a foot controller that just swiches between these patches or that can be assigned to switch between them?

    Thanks in advance

    Yes you can control the push function of the white encoder via MIDI CC (continuous controller) on the V256. Page 15 of the manual has a table listing the CC parameters and what they control on the V256. CC30 is the encoder press, when you send a value of 127 the V256 performs an encoder press.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.