I added the SPDT switch, put away the iron, screwed it all back together, and just realized I didn’t solder the ground to the middle pole but to the top one. The result is a very middybassy boost. Will there be any difference if I switch their places? Thanks!
Yes, if you don’t wire it like I showed its not right.
Unless of course you soldered the two red wires (red in my diagram) to the middle lug and the two blue wires (blue in my diagram) to the top lug, it makes no difference.
So long as both colored wires are on the same lug its fine.
In the diagram, which colored wires are meant to go to the board and which colored wires are meant to go to the component ends? I thought red was for the component ends and blue was for the pcb. Was I right?
