Home › Forums › Help/Technical Questions › Switchblade mod question

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • February 21, 2011 at 9:58 am #81390
    TenSecondTed
    Member

    Hi Guys

    Hope this isn’t too silly a question.

    I want to change my switchblade so that the ‘B’ output stays in the same place but the ‘A’ output is moved to come out of the TOP of the pedal (where the power supply would be – if it had one).

    Problem is, both the ‘A’ and ‘B’ jacks are mounted on a single PCB.

    Would it be ok to cut the PCB in half (so I can move the ‘B’ jack to a new position) and just solder a wire across to reconnect the broken joint?

    Sorry, but my electrical knowledge is zero!

    Thanks

    February 21, 2011 at 8:35 pm #114419
    The Chili Brian
    Member

    Yeah, you’re good. It shouldn’t affect it at all, really. I’ve never done it before, though.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.