Thanks for the quick reply. No issues at all. I have two identical Bass cabinets and I am going to add wadding inside one of them. Then I would like to use the Switch Blade to a/b them to compare.

An amp tech familiar with my model amplifier did the math to determine what specs I would need in regards to the switch.

I pulled the switch out of the box and did not see any specs on it so I thought I would ask here.

I’m wanting to use it exactly as I described in my previous post. To further clarify I intended to run a speaker cable from the speaker out on my amplifier into the Y input of the SwitchBlade. I would also run a speaker cable out of both the A and B jacks into a speaker cabinet.

Why would I think I could use the SwitchBlade for this application ? Because the manual/instruction sheet that was supplied with my SwitchBlade indicates I can indeed use it for that application. Since no specs are listed on that document, that is why I’m asking for a part number or specs of the switch.

Perhaps you are referring to the SwitchBlade+ which is not the product I am inquiring about.

I took a look at your online instruction page for the SwitchBlade+ and it does not list the application I am inquiring about.

However your online page showing the instructions for the SwitchBlade has the same text as the instructions that were supplied with my SwitchBlade I purchased new.

https://www.ehx.com/products/switchblade/instructions

If you don’t know the part number or specs of the switch itself please ask another member of EHX tech support if they can answer my question.

tia

OK, I submitted my question to the email address you provided.

I actually called and asked tech support before I asked here. No luck on that phone call.

Perhaps third time will be the charm. We’ll see.

Thank you, that’s what I was looking for and will be helpful and determining if my particular model amp will be safe using it for my particular application.

Good deal