Home › Forums › Help/Technical Questions › Small Clone depth pot

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • March 25, 2010 at 4:36 am #80084
    jeromeplank
    Member

    I tried to mod my Small Clone to add a depth pot and I think I’m doing something wrong. I found a site online that said to use a 10k linear pot. I’ve desoldered the switch, removed the resistor marked R27 on my board, and soldered two lugs of the pot in place. The knob goes from almost no depth to just about full very quickly and then there’s no change through the rest of the rotation. Do I need to remove additional resistors to get this mod to work or do I need to try a pot of a different taper/value?

    April 22, 2010 at 3:13 am #91858
    Mr.Grim
    Member

    im sure you need to try a different pot, but unfortunately i can not suggest the proper one.

    April 22, 2010 at 4:21 am #91859
    efilho
    Member

    Are you using a logaritmic or a linear pot?

    April 22, 2010 at 7:29 pm #91132
    SanquiFlerb
    Member

    He said it’s lin. Use a reverse logaritmic instead.

    June 11, 2010 at 12:35 am #101477
    efilho
    Member
    Quote:
    I tried to mod my Small Clone to add a depth pot and I think I’m doing something wrong. I found a site online that said to use a 10k linear pot. I’ve desoldered the switch, removed the resistor marked R27 on my board, and soldered two lugs of the pot in place. The knob goes from almost no depth to just about full very quickly and then there’s no change through the rest of the rotation. Do I need to remove additional resistors to get this mod to work or do I need to try a pot of a different taper/value?

    So…. did you work it out? We’re curious!!!

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.