Home › Forums › Help/Technical Questions › Q: Cockfight “fuzz thru” PCB dipswitch?

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 3, 2020 at 9:32 pm #86413
    TreadOnMe
    Member

    I’m looking for a dipswitch on the PCB of a Cockfight pedal. According to the manual:

    On the PCB there is a small DIP switch that changes
    FUZZ OFF to FUZZ THROUGH mode. In FUZZ THROUGH mode the filter section
    is bypassed and removed from the signal path. In this mode the knobs FREQ,
    BOTTOM and switch CRY/TALK have no effect on the sound.

    Here’s a pic: https://ibb.co/Db1wTRn

    Let me know if you can find it. Thanks

    September 4, 2020 at 5:23 pm #126398
    IOSEPHVS
    Participant
    Quote:
    I’m looking for a dipswitch on the PCB of a Cockfight pedal. According to the manual:

    On the PCB there is a small DIP switch that changes
    FUZZ OFF to FUZZ THROUGH mode. In FUZZ THROUGH mode the filter section
    is bypassed and removed from the signal path. In this mode the knobs FREQ,
    BOTTOM and switch CRY/TALK have no effect on the sound.

    Here’s a pic: https://ibb.co/Db1wTRn

    Let me know if you can find it. Thanks

    If I remember correctly, early versions of the Cock Fight did not have this option.

    September 5, 2020 at 6:22 am #126400
    TreadOnMe
    Member

    You’re correct. EHX customer support emailed me the following response:

    Quote:
    The FUZZ-THROUGH update started on the rev. D boards and came after the initial release, which was rev. C. It appears that you have an older revision of the pedal.
  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.