- This topic has 4 replies, 3 voices, and was last updated 14 years ago by .
Viewing 5 posts - 1 through 5 (of 5 total)
Viewing 5 posts - 1 through 5 (of 5 total)
- You must be logged in to reply to this topic.
Home › Forums › Help/Technical Questions › Pulsar rate slows/stops
Hey,
I’ve been having an issue with my Pulsar (model prior to new stereo version). The rate, when active often slows, stops, or changes. I find that depressing the metal face plate will correct this, but I’d rather it remain constant as set. Any ideas? The pedal is in a chain on my board, connected via a 1-Spot power source. The feet are on the pedal (not velcro’d).
Any ideas? I’ve opened it up, but there doesn’t seem to be any loose connections.
Thanks
It’s either a bad rate pot or a bad solder joint.
Are there any schematics available for it? Or do you know the pot that would potentially need replacing?
Schematics aren’t available for current production units. I’d look at the Rate pot or something on the board close to it.
1K linear…