They all should, unless your microsynth is the old one that needs 40v. If it’s the new one that needs 9V, you’re golden. Don’t worry that their adapters say 9.6V, they’ll work fine with the PP2+.

Just remember to read the manual before plugging anything in, so that you don’t hook up anything wrong or have the DIP switches switched to a higher voltage or something. That could be bad.

Also, the 5 and 6 outputs when their DIP is switched to 9V mode provide 250ma of current as opposed to 100ma of current like the others do. You want to try to put the higher current drawing 9V pedals on those two outputs, otherwise they may be noisy. I’m not sure of the current draws of your pedals, but it’s easy to figure out which ones are the most demanding through trial and error. If you hook up a pedal on one of the 9V 100ma outs, and it is noisy, switch it to the 9V 250ma out.