Home › Forums › Help/Technical Questions › Oceans 11 power supply

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • August 12, 2018 at 1:20 pm #85424
    Phruzao
    Member

    Hello!
    I don’t have space for a new power supply on my board and I am running a voodoo lab pedal power plus 2…

    My current reverb is using the 100ma output. Can the
    oceans 11 runs 9v 100ma? The manual says 150ma… What can I expect running less current? The pedal won’t work?

    August 12, 2018 at 1:51 pm #124181
    EHX STAFF
    Keymaster

    People have had issues with that supply.

    August 12, 2018 at 1:53 pm #124182
    Phruzao
    Member
    Quote:
    People have had issues with that supply.

    What kind of issue??? Using what output?

    August 12, 2018 at 2:41 pm #124183
    EHX STAFF
    Keymaster

    The pedal not starting up…cutting in and out and noise.
    Various outputs.

    August 12, 2018 at 2:43 pm #124184
    EHX STAFF
    Keymaster

    100ma is smaller than required for the Oceans.

    March 22, 2019 at 4:31 pm #124986
    Draygore
    Member

    Hi,

    My existing multi power supply unit has 100ma and 500ma outputs. Would I be able to use the 500ma output for my Oceans 11 pedal? The 100ma output causes some issues with some of the settings

    Thanks

    March 22, 2019 at 5:19 pm #124987
    EHX STAFF
    Keymaster

    100ma is to small.
    500ma is fine but may cause noise if daisy chained.
    You will have to try if its not our supply and its impossible for us to know.

    November 25, 2020 at 7:14 pm #126647
    Turbojangles
    Member

    What if I use output 5 or 6 on a Voodoo Pedal Power 2 with the DIP switch turned ON to 12v? Would that be ok to power the Oceans 11?

    November 26, 2020 at 11:42 pm #126649
    EHX STAFF
    Keymaster

    NO
    9 volts or you could blow a protection diode.

  • Author
    Posts
Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.