Home › Forums › Ideas / Suggestions / Feedback › Muff OD with integrated Signal Pad

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • April 15, 2009 at 5:38 pm #78072
    echobaseone
    Member

    I LOVE my Nano Muff…but only with my guitar volume backed off to about 8…anything more pushes it from the sweetest overdrive to, well, muffled dirt…I’m wondering if a Signal Pad used in conjunction with the Muff would enable me to not adjust the volume on the fly. Of course, then I’m trying to hit two pedals at once.
    It would be nice if there was a signal/level control on the Nano Muff. That’s what I’m trying to say.

    April 15, 2009 at 6:09 pm #95704
    JRiggles
    Member

    Crack it open and see if there’s a trimpot that controls the input signal level, that’s probably a good place to start.

    April 15, 2009 at 7:27 pm #95708
    rafsbio
    Member
    Quote:
    I LOVE my Nano Muff…but only with my guitar volume backed off to about 8…anything more pushes it from the sweetest overdrive to, well, muffled dirt…I’m wondering if a Signal Pad used in conjunction with the Muff would enable me to not adjust the volume on the fly. Of course, then I’m trying to hit two pedals at once.
    It would be nice if there was a signal/level control on the Nano Muff. That’s what I’m trying to say.

    I feel the same about my Nano Muff.
    I’ll open mine and check for trimpots, but I don’t think there is…

    April 15, 2009 at 7:44 pm #95709
    rafsbio
    Member

    Nope. No trimpots.

    April 16, 2009 at 3:58 am #95722
    echobaseone
    Member

    one of the guys on offsetguitars.com suggested a resistor change at the input. not sure how to go about that though.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.