Home › Forums › Help/Technical Questions › Micro Synth PREAMP GAIN ADJUSTMENT: Trim Pot adjustement

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • January 23, 2010 at 4:04 pm #79744
    lesvanperfek
    Member

    Hi all,
    I just bought a used Micro Synth and read about the PREAMP GAIN ADJUSTMENT being factory set for single coil PUs. I use principally Strats and Teles…
    Not knowing if the previous users had tweaked the Trim Pot, is there anyway to know VISUALLY how to reposition the trim pot to the factory settings?

    I cannot see any numbers on the dial (trim pot)

    Any help would be greatly appreciated.

    Thanks,

    Les Van Perfek

    January 23, 2010 at 11:37 pm #106754
    dsl1
    Member

    If you can, take a picture of the Trim Pot & send an email to:

    https://www.ehx.com/about/contact

    or

    http://www.newsensor.com/CutomerServices.aspx

    January 24, 2010 at 1:50 am #106755
    Ned Flanders
    Moderator

    A picture wont be able to accurately tell you anything as trim pots vary in tolerance and a setting on one trim/pedal wont necessarily be identical on another, not to mention all the other components playing a part in it.

    Just read the manual about it and adjust it till it sounds good in bypass mode. Either that or just bypass the pre-amp, its what I done with mine as I didn’t like the sound of it in bypass mode. You will need a multi meter to do so.

    January 26, 2010 at 12:35 am #106821
    lesvanperfek
    Member

    Thanks guys for this information. Much appreciated!

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.