Home › Forums › Help/Technical Questions › Leberty Bell please HELP!!!!!!!!!!!!

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • February 26, 2010 at 7:22 pm #79942
    Mr.Grim
    Member

    i decided to built 2 simple projects i found online and i built them into one box with 4 other effects (6 total) well after i built the PC boards and had the other parts set up in the Hammond box, i went back to the diagram to wire everything together, and to my horror i forgot to notice that they are not wired up with a 3PDT switch and a LED!

    i searched here in the forum for your previous postings that i have seen and i cant get any of them to match. can you make me a diagram for these 2 projects please?!

    also they show them wired up to a 9V battery snap, will it make a difference if i just wire it up to a EHX style power jack, as thats how the rest of the unit is being powered.

    here they are:
    http://smallbox.zeonhost.com/projects/lpb1/index.html

    and:
    http://smallbox.zeonhost.com/projects/fface/

    THANK YOU THANK YOU THANK YOU!!!!!!!!!!!!!!!!!

    February 26, 2010 at 8:56 pm #107973
    julian
    Moderator

    By EHX style, do you mean 3.5 mm male connector? If so, make sure you connect the polarity right, because I think those are center positive.

    I’m looking for a good diagram of 3dpt wiring. I’ve found a couple but they’re incorrect. Maybe I’ll just make one.

    February 26, 2010 at 9:10 pm #107975
    julian
    Moderator

    There are a bunch of diagrams here:

    http://www.generalguitargadgets.com/content/view/33/27/

    this one looks good:
    http://www.generalguitargadgets.com/diagrams/switch_lo_3pdt_ig_dcjack.gif

    But one thing I’d be concerned about- is that fuzzface circuit positive or negative ground? It is PNP after all.

    February 26, 2010 at 10:22 pm #107978
    Ned Flanders
    Moderator

    That diagram is fine but if you still need help PM me.

    But here’s a diagram anyways, I come up with this TB wiring method and its all I use.

    http://i1016.photobucket.com/albums/af286/fenderamerica/Pedal Schematics/MYTBSWITCH.png

    The LED positive goes to a 2k7 resistor then to 9VDC.

    February 27, 2010 at 1:35 am #107994
    Mr.Grim
    Member

    Thanks liberty bell, but i have seen that pic of yours and unfortunetly im not smart enuf for it to help me. the wiring dont match the one in the diagram for me to translate it, and i can tell what wires are positive and ground, but i dont know what ones are effect in/out/ ect, off the board.

    February 27, 2010 at 1:46 am #107995
    julian
    Moderator

    no wonder, those diagrams you posted make me sick just looking at!

    Easiest way is to look at what wires go to the switch from the board. On both it’s the light blue and green wires.

    February 27, 2010 at 2:04 am #107998
    Mr.Grim
    Member

    thanks Julian, i did suspect those 2 wires, but unfortunately i cant tell what one is what!?!?

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.