i have many pedals and use 3 1spot chains for most of them, i don’t see any problems for you if you were to use the 1spot to power that chain at all.

the only issue that i have herd of was with the SMMH, sum people get undesired results when combining it on a chain with other pedals, but personally i never had an issue, so if you were to decide and try it, it wont hurt, you will just have to see if it works out or not.

Any 9v analog EH pedal should be fine with a chain, except the nano clone and the muff od.

My 2 cents: On a single one spot I have a Boss tuner, Boss DD5 delay, two Fuzzhugger fuzzes, Ring Thing, and SMMH. Never a problem. Just to be safe, I started putting the two fuzzes (both analog) on a separate one spot just to head-off any potential interference. But I never actually had a problem.

EDIT: I forgot that when I ran a Sovtek Muff on the same line with a DanO Fab Tone, I did have a very obvious conflict. But the Sovtek muff only had a battery so I had to use a battery adapter and I had even more pedals on the chain at the time. FYI.

Well it doesn’t need to be daisy chained, but why not? Put the SMMH on there too. Oh wait you may only have a five-pedal connector. Well either way you should be fine.

i think its a trial and error kinda thing, i hear from a lot of people that it dont work correctly or well on a daisy chain with analog effects, but i have currently 12 pedals on my board, and 9 of them are on a 1spot chain, and yes one is my SMMH, and i change my board around like once a month, so its always different. but the SMMH is always there and its always on a chain.

so give it a try, it definitely wont hurt it at all, it just may not work as well or make noise, if not then your all set!

try it… you won’t damage anything, I used to get a high pitched whine when I chained my SMM/H with some pedals, but other people don’t get this at all, so you’ll just have to see.