Hi there. I have a near new Bass Micro Synth pedal. It definitely has a learning curve but I’m having fun with it so far. However I am having some issues that I can’t sort out.

– What is the optimal way to set up the internal trim pot? Where should all the sliders be set when setting that pot?

– is it normal that the square wave adds a huge amount of volume as you slide it up?

– is it normal that the overall output volume is quite a bit lower than when the pedal is bypassed? If I max the internal pot I can get the output close, but it distorts badly.

– no matter where I set the internal pot and/or the trigger, the low octave seems to “pulse” in and out at a fairly steady rate, even when I’m playing in higher registers. Is this normal?

I’m playing a passive Fender P Bass, using an Empress compressor before the BSM. I’m powering the pedal with a Truetone CS7 isolated power supply.

Please help me out, thanks ahead of time!

Terry