Home › Forums › Help/Technical Questions › Barrel connector Little Big Muff Pi

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • March 3, 2009 at 8:57 pm #77836
    rksmith357
    Member

    My LBMP barrel connector stopped working. This is a first for me. I’ve never had an EH pedal that wasn’t bullet proof. Well not my fault anyway just stopped working. No submersion in beer, not dropped from a stage and crushed by a dork in a golf cart etc… hehehe Life is good.

    Anyway, I could solder on a new one if anyone has a source or what’s it cost to have it done at EH? They’d probably do a board swap. If best recommended course of action is EH what’s the process? Do I call 718-937-8300?

    Green board info:
    EH, EC-D2 Rev. B, 2005 new sensor corp

    Thanks in advance,

    Roy

    March 3, 2009 at 9:16 pm #94174
    FUZZ (EHX Staff)
    Member

    If it’s still under warrenty, we can send you that part no problem at all. In fact, email your address privately and I will put one in the mail for you.

    March 3, 2009 at 10:19 pm #94177
    Ned Flanders
    Moderator

    Are you sure its the barrel or another problem?

    March 3, 2009 at 10:38 pm #94179
    rksmith357
    Member

    I don’t know if the problem is actually in the jack for sure. It just seems most likely. I plug in the external power supply and it bypasses the battery but the pedal goes dead, remove plug make sure there’s a good battery and we’re rocking. Therefore we are talking something requiring more information than I have since I would only remove the board to replace the jack. I can perform these simple tasks. Even though I’m comfortable with following directions I am by no stretch of the imagination an engineer. Therefore replacing the jack is a no harm done low cost most likely fix.

    -Roy

    March 3, 2009 at 11:08 pm #94180
    Ned Flanders
    Moderator

    Contact EHX, then send it in to them for repair.

    March 4, 2009 at 6:56 am #94185
    julian
    Moderator

    mine stopped working too, even though they’re the industry standard, I’ve heard arguments that the 1/8″ connectors are far superior.

    What I did was simply use a battery snap connector and ignored the problem

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.