Home › Forums › Help/Technical Questions › Erase a loop with 22500 looper

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 19, 2020 at 12:49 pm #86430
    gside
    Member

    Hi,

    I installed the latest firmware (v36) to be able to erase loops while standing up.
    But I found almost impossible to push simultaneously two switches, when using a pedal board (missing a third leg for that…)

    Is there any other way to erase a loop with FW ? (On most pdeals I know, this is as simple as holding a FW for a few seconds)

    If you use this pedal live, how do you erase a loop (for exemple, to restart another loop from blank)?
    The only way I found is to switch to the next unused bank. But if I also preloaded some banks with loops, this again, becomes difficult to use…

    Or is anything planned by Electro Harmonix to fix this?

    Thanks,
    g.

    September 23, 2020 at 1:23 pm #126460
    Flick (EHX Staff)
    Moderator

    With the latest version 36 firmware on the 22500:

    Erasing Loop A only: requires two feet, there’s no way around it. First press and hold the STOP/TAP footswitch then press and release the LOOP A footswitch.

    Erasing Loop B only: this can be done with one foot. First press and hold the STOP/TAP footswitch with the right side of your foot, then press down on the LOOP B footswitch with the left side of the same foot.

    Erasing both Loop A and Loop B simultaneously: can be done with one foot if you turn your foot sideways, which I appreciate might not be too easy to do depending on how the pedalboard is set up. Basically you would first press and hold the STOP/TAP footswitch with the heel of your foot then press the LOOP A and LOOP B footswitches the middle and toe sections of the same foot.

    One important note, even though the STOP/TAP footswitch must be held down to erase either loop, you do not need to hold it down for any significant time, just press STOP/TAP first, then the other two footswitches.

    September 23, 2020 at 4:55 pm #126462
    gside
    Member

    Thanks Flick for your answer.

    Erasing a loop with a simple (one foot) FW action seems a must for a looper, at least for me. Hope EHX will be able to release a new firmware.

    Unfortunately for me it was a no go, and I just sold my 22500 today.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.