- This topic has 2 replies, 2 voices, and was last updated 5 years, 10 months ago by .
-
After 3 weeks , My 95000 looper experienced the following unresolved problems:
1) record button sticking, ( may loops do not stop immediately after i record a loop, causing loops to over record my guitar input chords, creating simple loop to sound sloopy
2) Cannot load an external audio track to play on 95000 (even after I met requirements)
3) Drum loops are only 4 bars long, how can i use them to record a loop, their too short
4) One of The LED numbers over the BAR indicator DON’T light up at times, then turns on & off
5) After erasing an overdub on a track , then when playback of the first loop plays back on the same track causes a silent space before my loop begins to playback , causing the loop to sound like it stopped & started again.
6) When Erasing recorded guitar tracks on a loop that has the 95000 default drum’s, causes the entire Drum track to erase, why should it erase, the guitar & drums are on separate tracks ?
7) After creating a loop & recording onto the tracks, when erasing every track (by holding the TRACK button down etc) The old Loop Start/End parameters are still stored within the erased loops, but no audio is on any of the tracks. I know I can also perform the hold the TRACK & UNDO button to possibly clear the old loop start/end parameter, but that procedure also erases the DRUM’s on that loop permanently .
When recording a New loop with Quantize , the 95000 does not Quantize my guitar to the nearest Beat, I’ve tried over & over, If your a fraction of a second off when hitting the RECORD button to end the loop recording, the loop repeats with the guitar recording on the loop to be
in-accurate & sounds like the loop is starting over in the middle of a chord the Quantize on the 95000 does not compensate when creating loops, the way that other looper quantizeI loaded the latest Firmware , Read the Manual 3 times , reached out to other EFX customers on the with similar if not the same issues on the EFX Forum blog & Google .
I followed the EFX tech support advice , & did resolve some smaller issues, but the issues mentioned above are still unresolved, I strongly feel my 95000 has a few malfunctions that cannot easily be resolved.Regards
Mario
When recording a New loop with Quantize , the 95000 does not Quantize my guitar to the nearest Beat, I’ve tried over & over, If your a fraction of a second off when hitting the RECORD button to end the loop recording, the loop repeats with the guitar recording on the loop to be- You must be logged in to reply to this topic.
