Home › Forums › Help/Technical Questions › 9,6V / 9V?

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • January 27, 2011 at 1:23 pm #81292
    Monaden
    Member

    Hi I have a box with five outputs with 9V (totally 1000 mA) and negative pin in the middle.
    Is it safe to use this to my four EHX pedals (9,6V)?
    Regards
    Monaden

    January 27, 2011 at 2:53 pm #114021
    TheGhostMachina
    Member

    What is the “box” and what are your 4 EHX pedals? Depending on the mA required by your pedals, there may not be enough juice.

    I use a DC Brick to power a BMPwTW, LPB-1, Stereo Pulsar, and Nano Dr. Q. But I need to power my POG2, DMB, and HOG independently because they require more mA to function properly.

    TGM

    January 27, 2011 at 3:47 pm #114023
    nightraven
    Member

    yeah it’ll be fine. and to the above poster – even with four digital pedals 1000mA will be enough.

    January 27, 2011 at 6:54 pm #114026
    TheGhostMachina
    Member

    Thank you, nightraven. Specs my say 1000mA is enough. But in practice my POG2, HOG, and DMB needed more. Especially when all on at the same time.

    TGM

    January 27, 2011 at 7:28 pm #114027
    C.J.
    Participant

    I can tell you that the POG2 doesn’t like power from a “switching” supply like the OneSpot. (even though it boasts 1700mA)

    in my experience, neither does the Ring Thing, Microsynth, even Freeze.

    they operate, but there is very obvious high-frequency noise that is so annoying.

    January 27, 2011 at 7:47 pm #114029
    TheGhostMachina
    Member

    I experienced a similar thing as you, C.J. Although not always noise.. My DMB would “brown out”, making the repeats even dirtier then normal. It sounds nix for some things, but not all the time. And I couldn’t use the mid to high ‘Q’ on my POG2, as that def made ‘white noise’.

    TGM

    January 29, 2011 at 7:30 am #114044
    splitpeamaster
    Member

    thanks guys good info!

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.