1. I wanted to put a new boss style power jack into my bassballs. I put it in and wired it up the same way that the other jack was wired– and now it doesn’t work. Any thoughts on what I might be doing wrong?
2. While I was doing this, I accidently disconnected the end of the LED that is not attached to the pedal switch. I’m not sure where it goes. I tried connecting it to the power jack and that blew the LED as there wasn’t a resistor attached. I’m guessing that it should go somewhere on the PCB, I just can’t see where. Any help would be appreciated.
Thanks man. I forgot to enable the email notification over at DIYStomboxes and didn’t think that anyone had responded.
As for the LED then, I should just look for a resistor that goes nowhere?
In the meantime, I already rigged up the LED with a resistor. Is there any harm in just connecting that to the jack as you would for a normal true bypass wiring job?
In the meantime, I already rigged up the LED with a resistor. Is there any harm in just connecting that to the jack as you would for a normal true bypass wiring job?
